Ringdale Thin Twinax Terminal LM-6488 User Manual download pdf (Page 9)

LM6488 User Manual

Page 9

Twinax Printer Session Configuration

To configure a twinax printer session, follow the

initial configuration steps as discussed earlier in

this document (Connection Manager, -

Configure, - Add, - NLynx Twinax Emulator)

and then at the “Twinax” tab type in a

Connection Name for the printer (PRINT1 for

example), click on the “Printer” button and then

select the appropriate printer emulation from the

available supported printer emulations, as

follows:

Select a unique IBM Host Address, remembering that the IBM Twinax line supports seven station

addresses (from 0 to 6) and if you duplicate an address that another device is already using, you will not

be able to connect to the IBM host and you may even bring the whole Twinax line down. Select the

appropriate “Host Character Set” and “Printing Method” (Direct to Printer Port is default).

The “General” and “Printer” tabs are self-explanatory so we will move on to the “Options” tab:

From the “Options” tab you can elect to use the

AS/400 printer setup defaults, or deselect

“Defaults” and custom configure the CPI, LPI

and Page Scaling options.

From this tab you can also configure

“EBCDIC Transparent Mode” and

“EBCDIC to ASCII Translation Pairs”.

Since these two options are dependant upon how

the printer application is configured at the IBM

Twinax host, you will need to refer to your

appropriate IBM administrator for advice and

guidance on the relevance of these options to

your terminal.

3812-01 5224-1, -2

4210-01 5225-1, -2, -3, -4

5219-D 5226-1, -2, -3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Ringdale Thin Twinax Terminal LM-6488 User Manual Page 9